Pressure reducing/relieving valve from Sun Hydraulics
Description
The direct-acting reducer/reliever main section is meant to act as an interface between a low flow pressure source at port 4 and a circuit with higher flow requirements. The valve will reduce a high primary pressure at the inlet (port 2) to a reduced pressure at port 1, with a full-flow relief function from port 1 to tank (port 3).
The valve incorporates a damped construction for stable operation allowing the use of high reduced pressure.
Read more ▼
- The valve is biased to the relieving mode with a 100 psi (7 bar) spring. Pressure at port 4 is directly added to the setting of the valve once this threshold is exceeded. For example, 1000 psi (70 bar) at port 4 will result in a setting of 900 psi (63 bar) at port 1.
- Maximum pressure at port 3 should be limited to 3000 psi (210 bar).
- All spring ranges are tested for correct operation with 5000 psi (350 bar) inlet pressure.
- Suitable for accumulator circuits since the absence of pilot control flow results in reduced secondary circuit leakage.
- Direct acting concept provides highly reliable operation in contaminated systems, especially at dead headed conditions.
- Direct operated version offers superior dynamic response compared to equivalent pilot operated models.
- Pressure on the drain (port 4) is directly additive to the valve setting at a 1:1 ratio and should not exceed 5000 psi (350 bar).
- Leakage specified in Technical Data is out of port 3 with a supply pressure of 2000 psi (140 bar) and the valve set at mid range. This leakage is directly proportional to pressure differential and inversely proportional to viscosity expressed in centistokes.
- Cartridges configured with EPDM seals are for use in systems with phosphate ester fluids. Exposure to petroleum based fluids, greases and lubricants will damage the seals.
- Full reverse flow from reduced pressure (port 1) to inlet (port 2) may cause the main spool to close. If reverse free flow is required in the circuit, consider adding a separate check valve to the circuit.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
Technical Data
Note: Data may vary by configuration. See CONFIGURATION section.
| Cavity |
T-22A |
| Series |
2 |
| Capacity |
20 gpm |
| Capacity (metric) |
80 L/min. |
| Maximum Operating Pressure |
5000 psi |
| Maximum Operating Pressure (metric) |
350 bar |
| Factory Pressure Settings Established at |
blocked control port (dead headed) |
| Maximum Valve Leakage at 110 SUS (24 cSt) |
3 in³/min.@1000 psi |
| Maximum Valve Leakage at 110 SUS (24 cSt) (metric) |
50 cc/min.@70 bar |
| Valve Hex Size |
1 1/8 in. |
| Valve Hex Size (metric) |
28,6 mm |
| Valve Installation Torque |
45 – 50 lbf ft |
| Valve Installation Torque (metric) |
61 – 68 Nm |
| Model Weight |
0.67 lb. |
| Model Weight (metric) |
0.30 kg. |
| Seal kit – Cartridge |
Viton: 990022006 |
Configuration Options
Control
Bias Pressure
Seal Material
