Hydnet - the specialist in intelligent hydraulic systems
Contact
PRBR

Pressure reducing valve from Sun Hydraulics

Description

Direct-acting, pressure reducing valves reduce a high primary pressure at the inlet (port 2) to a constant reduced pressure at port 1. These valves incorporate a damped construction for stable operation allowing the use of high reduced pressure.

Read more ▼
  • Note: This valve has no relieving capability. It should not be used in a dead-headed application. If the reduced pressure side of the circuit has very low leakage the pressure may rise significantly. The pressure rise will vary from valve to valve.
  • This type of valve, PR*R, is a good replacement for an LP*C as a normally open, restrictive compensating element if a higher pressure drop across an orifice is needed.
  • Cartridges configured with EPDM seals are for use in systems with phosphate ester fluids. Exposure to petroleum based fluids, greases and lubricants will damage the seals.
  • Full reverse flow from reduced pressure (port 1) to inlet (port 2) may cause the main spool to close. If reverse free flow is required in the circuit, consider adding a separate check valve to the circuit.
  • All spring ranges are tested for correct operation with 5000 psi (350 bar) inlet pressure.
  • Suitable for accumulator circuits since the absence of pilot control flow results in reduced secondary circuit leakage.
  • Direct operated version offers superior dynamic response compared to equivalent pilot operated models.
  • Pressure at port 3 is directly additive to the valve setting at a 1:1 ratio and should not exceed 5000 psi (350 bar).
  • Leakage specified in Technical Data is out of port 3 with a supply pressure of 2000 psi (140 bar) and the valve set at mid range. This leakage is directly proportional to pressure differential and inversely proportional to viscosity expressed in centistokes.
  • Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.

Technical Data

Note: Data may vary by configuration. See CONFIGURATION section.

Cavity T-163A
Series 0
Capacity 5 gpm
Capacity (metric) 20 L/min.
Maximum Operating Pressure 5000 psi
Maximum Operating Pressure (metric) 350 bar
Factory Pressure Settings Established at 0.25 gpm
Maximum Valve Leakage at 110 SUS (24 cSt) 2 in³/min.
Maximum Valve Leakage at 110 SUS (24 cSt) (metric) 30 cc/min.
Adjustment – No. of CW Turns from Min. to Max. setting 5
Valve Hex Size 3/4 in.
Valve Hex Size (metric) 19,1 mm
Valve Installation Torque 20 – 25 lbf ft
Valve Installation Torque (metric) 27 – 33 Nm
Adjustment Screw Internal Hex Size 5/32 in.
Adjustment Screw Internal Hex Size (metric) 4 mm
Locknut Hex Size 1/2 in.
Locknut Hex Size (metric) 12,7 mm
Locknut Torque 80 – 90 lbf in.
Locknut Torque (metric) 9 – 10 Nm
Model Weight 0.30 lb.
Model Weight (metric) 0.14 kg.
Seal kit – Cartridge Viton: 990163006

Configuration Options

Control

C Tamper Resistant – Factory Set
K Handknob
L Standard Screw Adjustment

Adjustment Range

A 500 – 3000 psi (35 – 210 bar), 700 psi (50 bar) Standard Setting
B 50 – 1500 psi (3,5 – 105 bar), 200 psi (14 bar) Standard Setting
D 25 – 800 psi (1,7 – 55 bar), 200 psi (14 bar) Standard Setting
E 25 – 400 psi (1,7 – 28 bar), 200 psi (14 bar) Standard Setting
S 25 – 200 psi (1,7 – 14 bar), 100 psi (7 bar) Standard Setting
W 750 – 4500 psi (50 – 315 bar), 1000 psi (70 bar) Standard Setting

Seal Material

N Buna-N
V Viton
E EPDM

Material/Coating

/AP Stainless Steel, Passivated
/LH Mild Steel, Zinc-Nickel
Cavity: T-163A
Nominal Capacity: 20 lpm (5 gpm)
Downloads
PDF
Possible variants

PRBRCAE, PRBR-CAE, PRBRCAE/AP, PRBR-CAE/AP, PRBRCAN, PRBR-CAN, PRBRCAN/AP, PRBR-CAN/AP, PRBRCAN/LH, PRBR-CAN/LH, PRBRCAV, PRBR-CAV, PRBRCAV/AP, PRBR-CAV/AP, PRBRCAV/LH, PRBR-CAV/LH, PRBRCBE, PRBR-CBE, PRBRCBE/AP, PRBR-CBE/AP, PRBRCBN, PRBR-CBN, PRBRCBN/AP, PRBR-CBN/AP, PRBRCBN/LH, PRBR-CBN/LH, PRBRCBV, PRBR-CBV, PRBRCBV/AP, PRBR-CBV/AP, PRBRCBV/LH, PRBR-CBV/LH, PRBRCDE, PRBR-CDE, PRBRCDE/AP, PRBR-CDE/AP, PRBRCDN, PRBR-CDN, PRBRCDN/AP, PRBR-CDN/AP, PRBRCDN/LH, PRBR-CDN/LH, PRBRCDV, PRBR-CDV, PRBRCDV/AP, PRBR-CDV/AP, PRBRCDV/LH, PRBR-CDV/LH, PRBRCEE, PRBR-CEE, PRBRCEE/AP, PRBR-CEE/AP, PRBRCEN, PRBR-CEN, PRBRCEN/AP, PRBR-CEN/AP, PRBRCEN/LH, PRBR-CEN/LH, PRBRCEV, PRBR-CEV, PRBRCEV/AP, PRBR-CEV/AP, PRBRCEV/LH, PRBR-CEV/LH, PRBRCSE, PRBR-CSE, PRBRCSE/AP, PRBR-CSE/AP, PRBRCSN, PRBR-CSN, PRBRCSN/AP, PRBR-CSN/AP, PRBRCSN/LH, PRBR-CSN/LH, PRBRCSV, PRBR-CSV, PRBRCSV/AP, PRBR-CSV/AP, PRBRCSV/LH, PRBR-CSV/LH, PRBRCWE, PRBR-CWE, PRBRCWE/AP, PRBR-CWE/AP, PRBRCWN, PRBR-CWN, PRBRCWN/AP, PRBR-CWN/AP, PRBRCWN/LH, PRBR-CWN/LH, PRBRCWV, PRBR-CWV, PRBRCWV/AP, PRBR-CWV/AP, PRBRCWV/LH, PRBR-CWV/LH, PRBRKAE, PRBR-KAE, PRBRKAN, PRBR-KAN, PRBRKAV, PRBR-KAV, PRBRKBE, PRBR-KBE, PRBRKBN, PRBR-KBN, PRBRKBV, PRBR-KBV, PRBRKDE, PRBR-KDE, PRBRKDN, PRBR-KDN, PRBRKDV, PRBR-KDV, PRBRKEE, PRBR-KEE, PRBRKEN, PRBR-KEN, PRBRKEV, PRBR-KEV, PRBRKSE, PRBR-KSE, PRBRKSN, PRBR-KSN, PRBRKSV, PRBR-KSV, PRBRKWE, PRBR-KWE, PRBRKWN, PRBR-KWN, PRBRKWV, PRBR-KWV, PRBRLAE, PRBR-LAE, PRBRLAE/AP, PRBR-LAE/AP, PRBRLAN, PRBR-LAN, PRBRLAN/AP, PRBR-LAN/AP, PRBRLAN/LH, PRBR-LAN/LH, PRBRLAV, PRBR-LAV, PRBRLAV/AP, PRBR-LAV/AP, PRBRLAV/LH, PRBR-LAV/LH, PRBRLBE, PRBR-LBE, PRBRLBE/AP, PRBR-LBE/AP, PRBRLBN, PRBR-LBN, PRBRLBN/AP, PRBR-LBN/AP, PRBRLBN/LH, PRBR-LBN/LH, PRBRLBV, PRBR-LBV, PRBRLBV/AP, PRBR-LBV/AP, PRBRLBV/LH, PRBR-LBV/LH, PRBRLDE, PRBR-LDE, PRBRLDE/AP, PRBR-LDE/AP, PRBRLDN, PRBR-LDN, PRBRLDN/AP, PRBR-LDN/AP, PRBRLDN/LH, PRBR-LDN/LH, PRBRLDV, PRBR-LDV, PRBRLDV/AP, PRBR-LDV/AP, PRBRLDV/LH, PRBR-LDV/LH, PRBRLEE, PRBR-LEE, PRBRLEE/AP, PRBR-LEE/AP, PRBRLEN, PRBR-LEN, PRBRLEN/AP, PRBR-LEN/AP, PRBRLEN/LH, PRBR-LEN/LH, PRBRLEV, PRBR-LEV, PRBRLEV/AP, PRBR-LEV/AP, PRBRLEV/LH, PRBR-LEV/LH, PRBRLSE, PRBR-LSE, PRBRLSE/AP, PRBR-LSE/AP, PRBRLSN, PRBR-LSN, PRBRLSN/AP, PRBR-LSN/AP, PRBRLSN/LH, PRBR-LSN/LH, PRBRLSV, PRBR-LSV, PRBRLSV/AP, PRBR-LSV/AP, PRBRLSV/LH, PRBR-LSV/LH, PRBRLWE, PRBR-LWE, PRBRLWE/AP, PRBR-LWE/AP, PRBRLWN, PRBR-LWN, PRBRLWN/AP, PRBR-LWN/AP, PRBRLWN/LH, PRBR-LWN/LH, PRBRLWV, PRBR-LWV, PRBRLWV/AP, PRBR-LWV/AP, PRBRLWV/LH, PRBR-LWV/LH