{"id":81196,"date":"2026-08-10T10:16:29","date_gmt":"2026-08-10T10:16:29","guid":{"rendered":"https:\/\/hydnet.se\/?p=81196"},"modified":"2026-08-10T10:16:29","modified_gmt":"2026-08-10T10:16:29","slug":"load-holding-valves-how-counterbalance-valves-work-and-how-to-choose-the-right-one","status":"publish","type":"post","link":"https:\/\/hydnet.se\/en\/load-holding-valves-how-counterbalance-valves-work-and-how-to-choose-the-right-one\/","title":{"rendered":"Load holding valves \u2013 how counterbalance valves work and how to choose the right one"},"content":{"rendered":"
\n

What is a load holding valve?<\/h2>\n

A load holding valve keeps a hydraulic load securely in place and prevents it from moving in an uncontrolled way if system pressure is lost \u2014 for example due to a burst hose, a valve closing, or a pump stopping. Other names for the same function are overcenter valve, counterbalance valve and load holding valve. This valve type is central to any application where an overrunning load, a cylinder or a hydraulic motor must be held safely without the drive system being actively pressurized: cranes, presses, lifts, drilling equipment and rotating drives.<\/p>\n

How a counterbalance valve works<\/h2>\n

A counterbalance valve combines two functions in a single cartridge. A check valve allows free flow from the directional valve (port 2) to the load (port 1) when the load is being driven. In the opposite direction \u2014 when the load tries to run away on its own \u2014 flow from port 1 to port 2 is held back by a direct-acting relief valve. That relief function is pilot-assisted: pilot pressure at port 3 (normally taken from the opposite side of the cylinder or motor) lowers the effective setting by a ratio determined by the pilot area. As long as the directional valve is in neutral, the relief function holds the load still; as soon as the directional valve opens for lowering or rotation, pilot pressure follows along and the valve opens smoothly in step with the load.<\/p>\n

A few practical reference points: set the counterbalance valve to at least 1.3 times the maximum load-induced pressure, expect the fully clockwise (minimum) setting to be below 14 bar (200 psi), and note that reseating occurs at a minimum of 85% of the set pressure in the standard configuration. Back pressure at port 2 raises the effective setting further \u2014 by a factor of (1 + pilot ratio) times the back pressure \u2014 which is worth accounting for in circuits with series-connected functions.<\/p>\n

Counterbalance valve or pilot-operated check valve?<\/h2>\n

Sun Hydraulics also makes a simpler alternative: the pilot-operated check valve (POCV), without a relief function or an adjustment screw. It opens outright once pilot pressure exceeds a threshold, without metering or throttling the load on the way. The choice between the two is rarely a close call:<\/p>\n